BIogas Plant Construction Plant Guide
Step by Step Guide to Constructing a Floating Drum Biogas Digester by Plastic 1000 letter and 1500 letter water tank part 1
Constructing a Floating Drum Biogas Digester outlet Part 2
water tank
|
pvc pipe
|
Add caption
|
cut the top off 1500 l digester tank
|
1500 l digester tank
|
1500 l digester tank with hole
|
outlet pipe at top of the tank
|
heat iron pipe for making hole in tank
|
make a 75 mm hole for inlet near the base of the tank on opposite side to the outlet
|
hole in tank
|
Step by Step Guide to Constructing a Floating Drum Biogas Digester outlet by Plastic 1000 letter and 1500 letter water tank part 2
pvc pipe
|
Put OUTLET pieces together like this and fit onto the DIGESTER tank
|
For all threaded fittings, apply white thread tape to
|
improve the seal
|
|
Add caption
|
Apply EPOXY RESIN around ALL joints
|
touching the tanks to make water/gas
|
tight seals
|
Step by Step Guide to Constructing a Floating Drum Biogas Digester by Plastic 1000 letter and 1500 letter water tank part 3
75mm fittings for the INLET/FEEDPIPE
|
Constructing a Floating Drum Biogas Digester inlet Part 3
|
biogas tank inlet volve
|
Constructing a Floating Drum Biogas Digester inlet Part 3
|
Insert FEED PIPE 1.2 m long into TEE
|
Constructing a Floating Drum Biogas Digester Part 4
Step by Step Guide to Constructing a Floating Drum Biogas Digester by Plastic 1000 letter and 1500 letter water tank
Make ½” (12.5mm)hole in the TOP of the gas holder tank. The hole should be near the EDGE of the tank
|
13.5 mm gas fittings
|
Fit the male adapter to the inside of gas holder tank
|
Add caption
|
Filling the tank/starting up the system
Place clean bricks in the bottom of the DIGESTER tank to support the GAS HOLDER tank and the INLET PIPE
|
Fill the DIGESTER tank
according to the
START UP instructions
|
Biogas plant digester
|
After filling the DIGESTER tank, place the GAS HOLDER tank inside the DIGESTER
|
biogas digester
|